Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
11-40 Reference — KODAK Drivers for TWAIN-Compliant PC Applications
“Timeout during
Command phase.”
“Timeout during Data
phase.”
“Timeout during Message
phase.”
“Timeout during Selection
phase.”
“Timeout during Status
phase.”
“Timeout waiting for
initial bus free phase.”
A problem with the
hardware has been
detected.
For any of this group of
messages, verify that all SCSI
connections are correct (if
necessary turn off all equipment
to alter the connections), make
sure the camera back has a
unique SCSI ID, and try again.
“TWAIN DCSxxx source
error. (Remaining wording
of message varies).”
A problem has occurred
with the software driver.
For any of this group of
messages, try the operation
again. If necessary, reinstall the
TWAIN driver and try again. If
the problem continues, contact
Kodak.
“TWAIN DCSxxx source
error. Low memory
condition encountered.
Free up some memory
and try again.”
There is not enough
memory to complete the
operation.
Be certain that the computer
meets the minimum system
requirements (refer to chapter 1).
Shut down other applications if
they are running and try again.
“TWAIN Error. Error
accessing data source.
Failure due to unknown
causes.”
A TWAIN-compliant
KODAK Driver has not
been installed or has
been installed
improperly.
Reinstall the driver as described
in chapter 5 and try again.
“TWAIN Error. Error
opening Data Source.
Failure due to unknown
causes.”
A TWAIN-compliant
KODAK Driver has not
been installed or has
been installed
improperly.
Reinstall the driver as described
in chapter 5 and try again.
Message Possible Cause Suggested Solution