Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
11-16 Reference — KODAK Drivers for TWAIN-Compliant PC Applications
If you are unable to open the driver (and therefore cannot
access the Control Panel containing the button), hold down
the Control key on your keyboard while accessing the driver
from your application. This will bypass the normal access to
the driver and will place you directly in the Control Panel
from which you can click on the U
PDATE CAMERA FIRMWARE
button.
If you are working with a camera back that does not cur-
rently have a PCMCIA card installed, updating camera back
firmware deletes the image in the camera back DRAM if one
is present.
After clicking this button, if you see a message asking you to
use the AC battery charger/adapter and to wait for several
minutes, follow these instructions and wait (to allow the
battery to charge) before clicking this button again.
F
IRMWARE VERSION Displays the version of the firmware (control program-
ming) in the camera back currently attached to the com-
puter.
NOTE: This firmware version may be different from the firmware
version displayed in an information box for an individual image.
The version in the control panel is the version of the camera back
currently connected to the computer. If a camera back with
different firmware was used to produce an image, then a different
firmware version will appear in the information box for that image.
DRIVER VERSION Displays the version of the software driver currently in use.
D
O SELF TEST Click this button to perform a diagnostic self-test of the DCS
465 Camera Back. Messages inform you of the outcome of
the self-test. These data can be helpful for field debugging
before you call Kodak with a problem.