Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-30 Preparing for Use with Mac
8. (Optional) Later, to disconnect the camera back from the Macintosh
computer, shut down the computer and all external SCSI devices.
Then restore the SCSI cables and terminator to the state they were in
before the camera back was connected. Do not leave a SCSI cable
with an empty connector dangling from a SCSI chain.
Skip the next section and continue at “Installing the KODAK Driver for
Adobe Photoshop Software (Macintosh) and the Calibration File” later in
this chapter.
B. Follow these steps if the last connected
device is terminated internally.
1. Turn off the Macintosh computer, and all connected SCSI devices.
IMPORTANT: Later when you connect and disconnect the Macintosh
computer and the DCS 465 Camera Back on a regular basis, make sure that
all devices are off. Some software and peripherals check the SCSI connection
periodically. If the Macintosh computer is on, and you connect the camera
back while the SCSI connection is being used, the Macintosh computer may
hang and you will need to restart.
2. Place the DCS 465 Camera Back in a convenient position next to the
last device in the SCSI chain of devices connected to your Macintosh
computer.
3. Connect the AC battery charger/adapter to the camera back as de-
scribed earlier in this chapter. Although this step is optional, we
recommend it whenever the camera back is connected to a computer.