Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9-44 Reference — DCS 465 Camera Back
Cleaning the Filter Glass
It is possible that the glass covering in the middle of the face of the
camera back (the side with the imager), called the KG5 filter glass, may
become dirty, or may break. This section describes how to clean that
glass, and how to replace it if necessary. (Replacement glass is available
as a spare part; refer to the appendix “Optional Equipment & Spare Parts
List.”)
Complete the steps below for each side of the filter glass.
1. Examine the filter glass. If there is lint on it (but not grease, finger-
prints, or other dirt), avoid touching the glass, and continue at step 9
below; otherwise continue with the next step.
2. Dampen one corner of the web cleaning pad sparingly with the
cleaning solution.
3. Wrap the damp corner of the cleaner pad over the forefinger of one
hand.
4. Hold the filter glass firmly in place on a clean flat surface with your
other hand.
5. Gently scrub the filter glass with the damp corner of the cleaner pad;
use a circular motion, and move over the entire glass. This action
should dislodge dirt and/or remove grease and fingerprints.