Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6-6 Using the DCS 465 Camera Back
6. With the camera back awake, check the battery indicator on the LCD.
If the segments are lighting in turn from bottom to top, the battery
is being charged by the attached AC battery charger/adapter; you
can operate the camera back normally in this state.
Without the AC battery charger/adapter, if the indicator shows
that the battery is low, recharge it or operate the camera back
from the AC battery charger/adapter.
Full battery
Blinks when battery exhausted
Low battery
2
⁄
3 full
Setting the ISO
This section describes how to set the ISO on the camera back.
NOTE: If a single ISO setting is available, there is no change in the displayed
setting when you press this button. If more than one ISO setting should become
available for your camera back, the ISO indicator cycles to the next supported
ISO.
1. If necessary wake the camera back as described earlier in this chapter.
NOTE: After five seconds of inactivity, the camera back automatically turns
off. As you complete these steps you may need to reawaken the camera back.