Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparing for Use with Mac 4-21
8. (Optional) Later, to disconnect the camera back from the Macintosh
computer, shut down the computer. Then disconnect the terminator
from the camera back. Disconnect the SCSI cable from the Macintosh
computer. Do not leave a SCSI cable with an empty connector/
terminator dangling from your Macintosh computer.
Skip the next sections and continue at “Installing the KODAK Driver for
Adobe Photoshop Software (Macintosh) and the Calibration File” later in
this chapter.
B. Follow these steps if no external devices are
connected and you are using a Macintosh
PowerBook computer.
The camera back has been successfully tested with a variety of
PowerBook models (except do not use the camera back with the model
100). However, the information in this section may not apply to all
PowerBook models.
For this installation you will need to supply an HDI-30-pin to 25-pin
Macintosh PowerBook SCSI adapter cable. Do not use a terminator.
NOTE: This cable is available in two versions; be certain that your cable is no
longer than three feet long, and that you obtain a cable for connecting a
PowerBook computer to a SCSI device, not for connecting a PowerBook com-
puter to a desktop Macintosh computer.
25-pin Connector
HDI-30-pin Connector
PowerBook SCSI Adapter Cable