Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Disassembly Flow 118
4.2.1.6 Rear Cover Removal
1. From the rear, remove two white screws (CPS:M3x12) securing the
optional interface cover, and remove the optional interface cover.
Figure 4-16. Interface Cover and Screw Removal
2. Remove the two white screws (CP:M3x6) securing the parallel interface
and remove the one white screw (CBS:M3x6) securing the USB interface.
3. Remove the one white screw (CBS:M3x6) securing the AC inlet.
Figure 4-17. Rear Cover Removal
4. Remove three white screws (CBS:M4x8) securing the lower section of the
cover, and remove three white screws (CBS:M4x8) securing the upper
section of the cover.
5. Remove the Rear Cover by pulling to the rear (lift and pull if necessary).
Optional
I/F cover
Two screws
One
screw
(lower
one)
Two screws
Rear
Cover
One
screw
Three screws
Three screws