Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Product Description Jumper Settings 52
1.10 Jumper Settings
The factory default settings for jumper and DIP switch on the Main Board
(C299MAIN) are as follows.
1.11 Initialization
There are three ways to initialize the EPSON Stylus Pro 7000:
Hardware initialization:
When the power is turned on or a cold-reset command is sent to the
printer (remote RS command), the printer does the following:
Initializes the printer mechanism
Clears the input data buffer
Clears the print buffer
Restores the default values
Software initialization:
When the printer receives an ESC @ command, it does the following:
Clears the print buffer
Restores the default values
Control panel (operator) initialization:
When the Pause button is pressed for more than two seconds or the
printer receives an -INIT signal (negative pulse) from the parallel
interface, the printer:
If a single sheet is loaded, the printer ejects the sheet. If roll paper is
loaded and Auto Cut is selected, the printer cuts the printed area off
and reverse feeds the paper. If roll paper is loaded and Cutter Off is
selected, the printer reverse feeds the paper.
Caps the printheads
Clears the input data buffer
Clears the print buffer
Resets the default values
The default values are shown below.
Page Position: Current paper position as page-start position
Line feed: 1/6”
Right margin: 237th character
Left margin: 1st character
Character pitch: 10 CPI
Print mode: Text mode (non-raster graphics mode)
Table 1-41. Jumper Settings
Type Number Setting
Jumper JP1 Jumpered
Jumper JP2 Jumpered
DIP-SW SWD1 “1” (1-4) OFF (Open)
DIP-SW SWD1 “2” (2-3) OFF (Open)