Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Disassembly Flow 155
4.2.3.24 Removing the Cover Sensor Assembly
1. Perform the Steps 1 to 13 in “I/C Holder Cover Removal” on page 116.
2. Separate the harnesses for the Cover Sensor Assembly from the six
harness connectors for the Ink Cartridge Sensor and harness bundle for
the Cover Sensor Assembly.
3. Remove the two (CP(W) M2x12) screws securing the Cover Sensor
Assembly and Cover SW Holder, and remove the Cover Sensor
Assembly.
Figure 4-83. Removing the Cover Sensor Assembly
ADJUSTMENT
REQUIRED
Perform the necessary adjustment listed in Table 5-2 in
Chapter 5. This adjustment is required to make the Cover
Sensor Assembly work interlocking with the close/open status
of the Front Cover.
Screws
(M2x12)
Cover SW
Holder
Cover Sensor
Assembly