Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Troubleshooting Errors That Require a Service Technician 94
SERVICE CALL 00010001
Problem
PF motor out of step - the length of the PF motor internal encoder’s
pulse is too long or too short compared to the regular pulse.
Solution
Make sure there is nothing blocking the grid rollers. If that does not
solve the problem, check the PF motor encoder connection. If there
still is a problem, try the following.
Check and adjust the PF Belt tension
Replace the PF motor
Replace the Main Board
SERVICE CALL 00010002
Problem
PF motor overcurrent - Feedback from the PF motor (IC35) driver’s 10-
pin output (sensor signal) indicates that the PF motor’s current is
irregular.
Solution
Replace the PF motor
Replace the Main Board
SERVICE CALL 00010003
Problem
PF in-position time-out - The in-position time is the amount of time
the printer waits to make sure the carriage is not moving when the
carriage comes to a stop. The rotary encoder is activate for the
predetermined “in-position time” and if the encoder sends a pulse,
this means the carriage is moving even though it is supposed to be at
a full stop, this generates an error.
Solution
Replace the PF motor
Replace the Main Board