Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Troubleshooting Troubleshooting Using the Error Messages 87
Table 3-8. Please Load xxx
Item Description
LCD
message
Please Load xxx
LED indicator
status
Paper check indicator is on and the currently selected paper path
indicator flashes. The paper path information is supplied by the
PP remote command.
Details
Roll paper and cut sheet size settings differ.
The PP remote command determines the paper path, and when
this setting and the paper setting made via the control panel
differ, this (paper mismatch) error occurs.
Recovery
Load the correct paper size, or change the setting in the control
panel/driver to match the size of the paper loaded in the printer.
When this error clears, printing begins.
Table 3-9. Paper Path Command and LED Indicators
PP Command
Roll
Auto Cut
Roll
No Cut
Sheet
Roll Paper Flashing Flashing On
Cut Sheets On On Flashing
Table 3-10. Please Load Paper
Item Description
LCD
message
Please Load Paper
LED indicator
status
The Paper Check indicator in on.
Details
The Paper Set Lever is in the release position.
While loading paper, the Paper Set Lever was pushed to the
release position.
Recovery
Pull the Lever forward to the paper set position to clear the error.
If the error doesn’t clear, check the Paper-Set-lever position
sensor for dust or foreign material. Also make sure the sensor is
properly connected to the Main board.
Table 3-11. Paper Jam
Item Description
LCD
message
Paper Jam
LED indicator
status
Paper Check sensor flashes
Details
There is a paper jam.
During a printing, feeding, or cutting operation the paper
jammed on a printer part. A paper jam is detected when one of
the paper-edge sensors is on and the CR motor has an out-of-
step error or an overcurrent error is detected.
Recovery
Remove the paper from the printer, turn the printer off and back
on, and try to print again. If the error recurs, make sure nothing
blocks the carriage path and there are no foreign objects inside
the printer.