Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Product Description Control Panel 37
1.4.2 Control Panel Messages
Printer status and error messages appear on the control panel display. The
table below lists the messages.
Table 1-28. Paper Source Indicator
Printer Status Indicator
Selected paper source On
Fatal error Flashing
Roll paper and sheet sizes are different Flashing
Reset, timer IC reset/NVRAM clear On
Table 1-29. Control Panel Messages
Display Message Meaning
SERVICE REQ. nnnnnnnn
Fatal error - see “Service Requests” on
page 48
TURN PWR OFF AND ON
Turn the printer off and on to reinitialize
RESET
In the process of re-initializing.
TRANSPORT PREP nn%
See “Transportation Mode” on page 53
POWER OFF
Preparing to shut down.
COVER OPEN
The cover is open. The carriage stops in place,
and the printhead can be damaged if the head
remains out of the capped position for a long
period of time.
SECURE PAPER LEVER
Paper Set lever is in the released and cannot
continue or begin a print, cleaning, or
initialization sequence.
NO INK CARTRIDGE
One or more cartridges are not installed
OPTION I/F ERROR
An unsupported Type-B interface card is
installed.
INK OUT
• A predetermined amount of ink has been
consumed after the cartridge has entered
the near-end condition.
• A near-end cartridge has been removed and
re-installed.
READY *
Can receive and print data.
WAIT *
Resetting Timer IC
Clearing NVRAM
Performing reset operation
Performing ink sequence operation
Initializing the printer
Initializing the paper
INK CHARGING nnn%
Initial charging of ink - shown in percent
completed
INK DRY xx MIN *
Printer waits xx minutes before the next print
job to allow enough time for ink to dry on
previous print job.
PRESS PAUSE BUTTON
Waiting for paper initialize start trigger
LOAD xxx PAPER
Wrong paper loaded or wrong paper source
selected on control panel.
LOAD PAPER
The Paper Set Lever is in the released position
(before printing). Pull the Paper Set lever
forward to the set position
PAPER JAM
Both front and rear paper sensors detect paper
and there is a carriage over-current or out of
step error. This is due to:
• Paper is jammed inside the printer
• Paper is obstructing the carriage path
during feeding or cutting operation.
PAPER NOT CUT
Printer did not cut the paper completely, or the
cut piece still remains over the paper sensor
PAPER NOT STRAIGHT
Paper skewed more than 3mm between the
leading and following edges. Check the
printout for skew and make sure no ink was
fired onto the platen.
Table 1-29. Control Panel Messages (continued)
Display Message Meaning