Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Troubleshooting Troubleshooting Using the Error Messages 85
Note: “Maintenance Call nnnn” is described in Table 3-3.
WARNINGS
Warning messages appear on the LCD display to warn users that a problem
may occur. The printer can still print and there is no effect on print quality;
however the messages do not go away until the possible problem is taken
care of or the printer enters the corresponding error condition. For example,
the Waste Ink Pads Near Full message will remain until the pads are replaced
and the counter is reset or until the pads become full and the printer enters an
error state.
Table 3-4. Warning/Error Messages
Error Type Message Refer to
Warning Ink Low page 99
Error
Paper Out page 99
Load xxx Paper page 100
Load Paper page 100
Paper Jam page 100
Cover Open page 100
Paper Not Cut page 101
Paper Not Straight page 101
Reload Paper page 101
Push Lever Down page 102
Ink Out page 102
No Ink Cartridge page 102
Remove Paper page 103
Option I/F Error page 103
Table 3-5. Ink Low
Item Description
LCD
message
Ink Low
LED indicator
status
The LED indicator for the ink cartridge that is low flashes.
Details
The printer has received the Near-End signal from one of the ink
low sensors. After the LCD displays the Ink Low warning, the
printer can print about one A1 sheet at 100% duty. By all means,
change the ink cartridge as soon as possible.
Once a “low-ink” cartridge has been removed, it will
automatically cause an ink-end error if replaced in the printer.
Only replace empty or low cartridges with new, full cartridges;
otherwise the ink counter cannot perform correctly.
Recovery Replace the old ink cartridge with a new one.