Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Troubleshooting Errors That Require a Service Technician 96
SERVICE CALL 00010006
Problem
CR motor overcurrent - Feedback from the CR motor (IC33) driver’s
10-pin output (Sense signal) indicates that the CR motor’s current is
irregular.
Solution
Check the CR cover, slightly loosen screws if necessary
Check the cutter housing, slightly loosen screws if necessary
Make sure no foreign material or ink tubes (from pump assembly) are
blocking the carriage path (see “Removing the Maintenance
Assembly” on page 143 for reassembly points)
Replace the CR motor
Replace the Main Board
SERVICE CALL 00010007
Problem
CR in-position time-out - The in-position time is the amount of time
the printer waits to make sure the carriage is not moving when the
carriage comes to a stop. The linear encoder is activate for the
predetermined “in-position time” and if the encoder sends a pulse,
this means the carriage is moving even though it is supposed to be at
a full stop, this generates an error.
Solution
Replace the encoder sensor
Replace the CR motor
Replace the Main Board
SERVICE CALL 00010008
Problem
Servo interrupt watchdog time-out error due to motor-drive control
related error
Solution
Replace the Main Board