Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Disassembly Flow 130
5. Remove one screw (CP(W) M3x6) securing the damper holder, unhook
the ink tubes from the damper holder, and then remove the damper
holder.
Figure 4-34. Damper Holder
6. Pull out the dampers. To pull out the dampers, place the tip of a flat-head
screwdriver or similar tool under the protrusion on the left side of a
damper and steady the damper with the forefinger of your other hand.
Gently but firmly pull the damper straight out.
Figure 4-35. Damper Removal
Ink tubes
Ink tubes
Damper
holder
One
screw
CHECK
POINT
If you only need to replace one head, you only need to perform
the following steps in regards to that printhead.
B head = left side; B, C, M
C head = right side; LC, LM, Y
CAUTION
Do not squeeze the dampers and try to only touch the edges of
the dampers. If pressure is applied to the middle of the
dampers, the ink inside will squirt out.
C head
dampers
B head
dampers
Screwdriver