Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Disassembly Flow 136
4.2.3.7 Removing the CR Encoder Sensor
1. Remove the cutter housing as described in “Removing the Cutter
Housing” on page 133.
2. Remove one screw (CPP M3x8) securing the CR Encoder Sensor, ground,
and washer (M3). Then remove the CR Encode Sensor.
Figure 4-47. CR Encoder Sensor Removal
4.2.3.8 Removing the P_Edge Sensor
1. Remove the cutter housing as described in “Removing the Cutter
Housing” on page 133.
2. Remove one screw (CBP M3x6) securing the P_Edge sensor and remove
the sensor.
Figure 4-48. P_Edge Sensor Removal
CR Encoder
Sensor
One screw
One screw
Inner Face
Outer Face
P_Edge sensor