Filter
Top Products
EPSON Stylus Pro 7000 Revision B
Troubleshooting Troubleshooting Using the Error Messages 86
ERRORS
Error messages appear on the LCD to notify the user that the printer cannot
print properly under the current conditions. When an error message appears,
printing stops and data transfer from the host PC stops. (The parallel interface
signal = /ERROR -> “LOW” and BUSY -> “HIGH” and data cannot be entered.)
Table 3-6. Maintenance Call nnnn
Item Description
LCD
message
Maintenance Call nnnn
nnnn = the replacement part code (see “Service Call 00000100”
on page 93)
LED indicator
status
No change.
Details
Maintenance required. The corresponding part described by the
nnnn has almost reached the end of its effective life. Service is
required.
Recovery
Replace the old part(s) with new ones (Maintenance Kit 1054038)
and reset the corresponding counters (Waste Ink and Cleaning).
Table 3-7. No Paper Loaded
Item Description
LCD
message
No Paper Loaded
LED indicator
status
Paper Check indicator is on
Details
No paper loaded or the end of the roll paper.
When printing on roll paper, if the Paper End sensor detects the
end of the roll paper, paper feeding stops and the paper is held
in place.
When printing on cut sheets, if the Paper End sensor detects the
end of the paper, printing as well as feeding stop and the paper
is held in place.
Recovery
Load paper.
For cut sheets, remove the printed sheet and load a new one.
After loading the new sheet, the error is cleared. If data from the
previous print job remains, the data is printed on the new sheet
according to the original paper-size data.
If this error occurs even if paper is properly loaded, check the P-
REAR sensor for obstruction or dust. Also make sure there is no
foreign material blocking the hole in the Paper Guide U where
the P-Rear sensor is located.