Filter
Top Products
Chapter 3 Operations
138
Controlling Cameras
You can switch the auto focus and manual focus by pressing “0” of the
numeric keys.
Manually controlling white balance
1 Select [White Balance], and confirm; 2 set [Manual], and confirm.
3 Select [R Gain] or [B Gain], and confirm; 4 move the slider to adjust the
values.
When not using control from this unit, select [Disable].
4
Press the ESC button to close the sub menu.
Resetting the Camera
After starting up this unit, carry out this procedure after powering the camera
supporting the VISCA protocol off and on again, or disconnecting and
reconnecting the VISCA cable.
Perform this operation even if “No Response” appears as the camera status.
1
Press the NEXT selection button to which the camera video is assigned.
A camera guide menu appears in the menu display.
2
With the jog roller, select [Control Setup], and confirm.
3
In the submenu, select [Reset Camera], and confirm.
Note
Note
Pan / Tilt Enable
Pan Reverse Off
Tilt Reverse Off
Zoom Enable
Focus Auto
lris Auto
White Balance Auto
R Gain 0
B Gain 0
Disable
Auto
B Manual
1
2
Pan / Tilt Enable
Pan Reverse Off
Tilt Reverse Off
Zoom Enable
Focus Auto
lris Auto
White Barance Auto
R Gain 0
B Gain 0
3
4
Pan / Tilt Enable
Pan Reverse Off
Tilt Reverse Off
Zoom Enable
Focus Auto
Iris Auto
White Balance Disable
R Gain 0
B Gain 0
Reset Camera SHIFT z+ -