Filter
Top Products
Chapter 3 Operations
168
Video/Audio Signal Adjustments and Settings
4
In the top menu select [Audio Output].
The [Audio Output] menu appears.
5
1 Select the item connected to the connector in step 2, and confirm;
2 while watching the video connected in step 1, adjust it with the slider.
The items for which you can adjust the delay time are as follows.
[PGM Delay]: Sets the delay time for the program output audio in frame
units.
[AUX1 Delay]: Sets the delay time for the audio output from the AUX1
connector in frame units.
[AUX2 Delay]: Sets the delay time for the audio output from the AUX2
connector in frame units.
[MIX OUT Delay]: Sets the delay time for the audio from the MIX output
in frame units.
• Adjusting the delay time may cause noise to occur.
• Video displayed on the PGM viewer lags several frames behind the video
output from the PGM video output connectors.
6
Press the MENU button, to close the menu.
Adjusting the Output Using the Oscillator Signal
This is for setting the output oscillator signal for use during adjustment.
1
Press the MENU button.
2
In the top menu, select [Audio Utility].
3
Select [OSC], and confirm, and set the oscillator signal output.
Setting the oscillator signal frequency
1 Select [OSC Freq.], and confirm; 2 select the frequency from the
submenu, and confirm.
Cautions
PGM Delay 2F
AUX1 Delay 2F
AUX1 OUT Level 0dB
AUX2 Delay 2F
AUX2 OUT Level 0dB
MIX OUT Delay 2F
MIX OUT Level
1
2
Audio Monitor
OSC
TB
OSC Freq. Off
OSC OUT Level -20dBFS
OSC OUT
Off
B 100Hz
440Hz
1kHz
10kHz
1
2