Filter
Top Products
49
Connections
Chapter 2 Preparations
Connections
This section describes how to connect devices for video and audio input and
output. The following figure shows an example system configuration and signal
flow. Refer to the pages indicated for details of how to make connections.
In addition, after connecting each device, you must configure settings on the unit
for each input and output signal. See page 56 for details on the settings of each
input and output signal.
AUDIO IN
Anycast Station
MIC/LINE
LINE
AUDIO OUT
VIDEO OUT
PGM
RGB
INTERCOM
VIDEO IN (OUT)
S VIDEO
COMPOSITE
DV (IN/OUT)
HDD (IN/OUT)
PC Video
Interface Module
(BKAW-550)
SD Video
Interface Module
(BKAW-570)
Serial Digital
Interface Module
(BKAW-580)
RGB
VISCA
HDD (IN/OUT)
SDI OUT
SDI IN
* Depending on the device, signal
input/output settings may be
required.
Refer also to the manuals provided
with the devices you are connecting.
Microphone (page 50)
Amplifier (page 54)
Camera with
VISCA support
(page 50)
Camcorder
(page 51)
VCR (page 52)
External hard disk
(page 52)
Intercom system (page 154)
Projector (page 53)
Plasma display (page 53)
Speaker
Signal flow
Computer (page 51)
Camcorder
(page 51)
Monitor
(page 53)