Filter
Top Products
161
Video/Audio Signal Adjustments and Settings
Chapter 3 Operations
Making the Gradation of SDI Input Signals Appear Smooth
(When Using the Serial Digital Interface Module)
Apply dynamic rounding to video signals input from an SDI connector to make
the gradation appear smooth.
Dynamic rounding is applied by default. If you do not want to apply dynamic
rounding, set this setting to [OFF].
1
Press the ACCESS button in the same column as the selection button for the
video signal you want to adjust.
2
1 In the top menu, select [Dynamic Rounding] and confirm; 2 select
[OFF] and confirm.
3
Press the ESC button to close the ACCESS menu.
If dynamic rounding is not performed, the video gradation will have visible
contouring artifacts because this unit drops the lower 2 bits of 10 bit SDI
input signals.
Adjusting the Clock Phase of RGB Signals
Of the video signals assigned to the selection buttons, adjust the RGB signals
input to the RGB input connectors.
Perform this adjustment to display small characters clearly.
1
Press the ACCESS button in the same column as the selection button for the
RGB signal you want to adjust.
2
1 In the top menu, select [Phase], and confirm; 2 adjust with the slider.
Adjusting Color Matte
Adjust the colors used for color matte, used as single-color backgrounds and so
on.
1
Press INT in the NEXT selection buttons.
The INT source selection menu appears.
Note
Luminance Level 100%
Luminance Offset 0 IRE
Chroma Level 100%
Hue 0
Phase
Dynamic Rounding
B Off
On
12
Luminance Level 100%
Luminance Offset 0 IRE
Chroma Level 100%
Hue 0
Phase
1
2