Filter
Top Products
Chapter 3 Operations
144
Recording Video and Audio on an External Device
Procedure for recording on a VCR
Program video and audio are always output as SDI signals from the PGM SDI
output connector.
Connect the VCR to the PGM SDI output connector and then start recording on
the VCR.
If the video output signal format (NTSC/PAL) of this unit is changed, the format
in which signals are output from the PGM SDI output connector also changes.
Recording Inputs on an External Hard Disk
You record the input source on an external hard disk connected to the i.Link
connector (HDD) of the interface module.
With video input to an interface module to which an external hard disk drive is
connected, and audio with the same source number as the video combined
together, two inputs can be recorded simultaneously.
For details of formatting an external hard disk, see the section “Formatting an
External Hard Disk” (page 179).
• It is not possible to record with an external recorder connected to the i.LINK
connector (HDD).
• When recording on the hard disk, be sure to read the section “External Hard
disk” (page 10).
Recorded settings and file details
Recorded settings
File details
Connecting an external hard disk
1
Connect the external hard disk to the i.LINK (HDD) connector of the
interface module (6-pin).
Connect the disk to the same interface module as the input you want to
record.
Note
Caution
Video
ACCESS menu settings (Adjustment is not possible for DV
video)
Audio
ACCESS menu [Input Trim] setting (analog audio only)
Top menu [Audio MIC/LINE Level] setting
File name YYMMDD-(source number)-(3-digit suffix) (.avi)
File format DV format (.avi)
Timecode Not included
I.LINK
S VIDEO
COMPOSITE
S VIDEO
COMPOSITE
S400
SD
OFF
ON
OFF
ON
SD
i.LINK connector (6-pin)