Filter
Top Products
Chapter 2 Preparations
58
Settings Related to Input Signals
If a serial digital interface module is installed, the SDI input connectors
appear in the list.
• You can only use one of the following from the same video input on the
same interface module: Composite (Composite video input connector), S-
Video (S-Video input connector), or DV (DV connector).
• It is not possible to assign more than one selection button to a single video
input connector. If you attempt to assign to a different selection button a
video input connector which has already been assigned to a selection
button, a confirmation message appears. If you then select [OK], the
assignment switches to the new selection button, and the material viewer
for the originally assigned selection button shows the indication “No Input
Assign”.
• About the DV signal lock time
When DV is selected for the input video, there is a delay until the DV
signal locks and the video appears.
• When a serial digital interface module is installed
You cannot assign the following audio to channel faders of source
numbers assigned for video of SDI signals.
- DV input audio
- Audio of SDI signals input through the other SDI input connector.
• The items in the list depend on the interface module installed in this unit.
• For details of [Control] in the menu 1, see “Registering Cameras to be
Controlled” (page 132).
4
If required, repeat step 3 similarly for the remaining selection buttons.
5
Press the MENU button to close the menu.
Notes
Caution
Notes
1
2
3
4
5
6
Source Name CAMERA1
Input S1-1 Composite
Control Off
No Assign
B SLOT1 IN1 Composite
S-Video
DV
SLOT1 IN2 Composite
S-Video
DV
SLOT2 IN1 SDI
SLOT2 IN2 SDI
SLOT3 IN1 RGB
SLOT3 IN2 RGB
When installed in slot 2