Filter
Top Products
145
Recording Video and Audio on an External Device
Chapter 3 Operations
2
Power on the hard disk.
Always connect the hard disk and power it on before starting up this unit.
3
Press the 1 (power) button on the side panel, to start up this unit.
The operation screen appears, and the device status for the source viewer for
the interface module to which the hard disk is connected shows the hard disk
number, remaining capacity, and available recording time.
When recording two sources simultaneously, the indicated remaining
capacity diminishes at twice the normal rate, and therefore the actual
remaining recording time is approximately half of that shown.
Starting recording for each input
1
Select the source to be recorded in the NEXT selection buttons.
The inputs that can be recorded are only those to the external interface
module to which the hard disk is connected (inputs for which the source
viewer shows the hard disk number and recording status).
2
Hold down the REC button and press the PLAY button.
The source viewer device status shows “REC PAUSE”.
The following confirmation message also appears at the same time.
Caution
Caution
Caution
Remaining capacity
Available recording time
Hard disk number
MENU
X
-
Y
REC
SHIFT
REC button
PLAY button