Filter
Top Products
Chapter 3 Operations
156
Monitoring Audio
Monitoring Audio
Use the internal speakers or the connected headphones to monitor the audio input
to the unit or the audio output from the unit.
Determining the Audio Signal Output Destinations
Select which output destinations to which the audio assigned for each channel
fader should be routed. For the output destination, you can select the PGM output
connectors, AUX output connectors, or MIX output connectors.
Output from the PGM output connectors
1
Press the ACCESS button in the same column of the channel fader to which
the audio you want to be the program output is assigned.
2
1
In the top menu, select [PGM OUT];
2
select [On], and confirm.
3
Press the ESC button to close the ACCESS menu.
You can also close the menu by pressing the same ACCESS button again.
Output from the AUX output connectors
This unit has two sets of AUX output connectors (AUX1, AUX2), and you can
create a mix balance with levels different from those of the PGM/MIX output.
1
Press the ACCESS button in the same column of the channel fader to which
the audio you want to be the AUX output is assigned.
2
1 In the top menu, select [AUX1 OUT] or [AUX2 OUT]; 2 in the
submenu, select [Pre-Fader] or [Post-Fader], and confirm.
The significance of the items is as follows.
[Pre-Fader]: Output the audio before adjustment by the channel faders. In
this case, the audio is output even when the CH ON button is Off.
[Post-Fader]: Output the audio after adjustment by the channel faders.
Note
Limiter/Compressor Off
Pan CNT
PGM OUT On
AUX1 OUT Off
AUX2 OUT Off
Off
B On
1
2
Pan CNT
PGM OUT On
AUX1 OUT Off
AUX2 OUT Off
MIX OUT On
Off
Pre-Fader
Post-Fader
Send Level 0dB
1
2