Filter
Top Products
Appendix
200
Maintenance
Upgrading the Operating Software
This section describes how to upgrade when there are improvements to the
operating software and hardware firmware.
When the external hard disk is connected to the unit, always disconnect it before
upgrading the operating software.
Information on upgrades
Information on software upgrades is available from the Anycast Station portal
site operated by Sony.
The following site also provides links to the portal site and information on
upgrades.
https://www.ecspert.sony.biz/ecsite/
https://servicesplus.us.sony.biz/SoftwarePlusSearch.aspx (for the customers in
the U.S.A.)
https://www.sonybiz.net/anycast (for the customers in Europe)
Download to a “Memory Stick” or USB flash memory.
Upgrade procedure
1
Insert a “Memory Stick” or USB flash memory holding the installation
program in the “Memory Stick” slot or USB connector on the side panel.
Before carrying out the following operation, plug the device into the
“Memory Stick” slot or USB connector used for installation only, and
remove other devices.
2
Press the 1 (power) button on the side panel.
This powers on the unit.
3
After the startup screen, press the F10 (Fn+0) key on the keyboard while the
message is displayed indicating that function key input is possible.
Caution
Cautions
FACTORY USE REMOTE
RGB
(
GUI
)
RESET
USB
NETWORK
18
15 9
15
96
“M
emory
S
t
i
c
k”
s
l
ot
1 (power) button USB connector