Filter
Top Products
195
Setting Live Streaming Transmission
Chapter 3 Operations
Starting and Stopping Streaming
Starting streaming
1
Make the settings described in “Configuring the Network Settings” (page
186) and “Setting Live Streaming Transmission” (page 188).
2
Press the ON LINE button.
The ON LINE button lights red, and a transmission starts.
Be sure to have a client computer available to check that a signal is being
transmitted, using Real Player.
Stopping streaming
Hold down the ESC button, and press the ON LINE button.
The ON LINE button goes off, and transmission ends.
It is not possible to stop while the status is shown as “Starting.” Once it shows
“Running” you can stop.
This section describes how to configure settings on the computer for viewing
material streamed from this unit. Perform these settings on network-ready
computers.
Downloading Real Player
Download Real Player from the Web site of RealNetworks, Inc.
Viewing streamed material from the unit
1
Start Real Player.
2
Click [Open] on the [File] menu.
3
Follow the procedure below to enter an URL.
When using the rtsp protocol for access
rtsp://Server Address[:Port]/broadcast/[Stream Path]/File Name.rm
* If port number 554 is to be used, you can omit [:Port] after the server
address.
When using the http protocol for access
http://Server Address[:Port]/ramgen/broadcast/[Stream Path]/File Name.rm
Caution
Settings Required for Viewing Streaming
MONI LEVEL
0
10
ON LINE
DIM TB
789
456
1
0
2
3
M
I
X
E
F
F
E
C
T
P
V
W
ON LINE button