Filter
Top Products
Chapter 3 Operations
192
Setting Live Streaming Transmission
6
1 Select [RTSP Port] and confirm; 2 enter the RTSP port set on the
external server in the input box and confirm.
Enter the RTSP port in [Ports] in the [Server Setup] settings of Helix
Administrator.
7
For [Ext (Account), 1 select [Listen Address] and confirm; 2 enter the IP
address of the unit which is seen from the external server when network
address translation [NAT] is used and confirm.
There is no need to enter an IP address if network address translation will not
be used.
8
For [Ext (Password)], 1 select [Port Range] and confirm; 2 enter the port
range set on the external server in the input box and confirm.
• Enter the same port range as that in [Receiver] of the [Broadcast-
Distribution] settings of Helix Administrator. Also, make sure the firewall
and other settings are configured so that communication between the unit
and Helix Administrator is not rejected.
• For [Ext (Account)], there is no need to configure the port range setting on
the unit, but match the firewall and other settings to the port range of
[RealNetworks Encoding] in the [Broadcasting] settings of the Helix
Administrator with which the unit will communicate.
Note
Note
Note
Output
Stream Name
Size 320x240
Rate
Clip Information
Server Setting
Connection Check
XXX.XXX.XXX.XXX
8080
554
Apply
Own
Ext (Account)
Ext (Password)
Server Address
HTTP Port
RTSP Port
12
Output
Stream Name
Size 320x240
Rate
Clip Information
Server Setting
Connection Check
XXX.XXX.XXX.XXX
5050
554
XXX.XXX.XXX.XXX
Apply
Own
Ext (Account)
Ext (Password)
Server Address
HTTP Port
RTSP Port
Listen Address
12
Output
Stream Name
Size 320x240
Rate
Clip Information
Server Setting
Connection Check
XXX.XXX.XXX.XXX
8080
554
. . .
30001 to 30020
Apply
Own
Ext (Account)
Ext (Password)
Server Address
HTTP Port
RTSP Port
Listen Address
Port Range
12