Filter
Top Products
61
Settings Related to Input Signals
Chapter 2 Preparations
- SDI embedded audio cannot be assigned simultaneously to CH (1/2) and
CH (3/4) of the same SDI input connector.
Similarly, select [Input (R)], and confirm; select the audio input connector
from the list, and confirm.
When the input audio signal reaches the reference level, the input signal
indication in the source viewer lights green and you can confirm that there is
an audio input.
4
Press the MENU button to close the menu.
Setting the MIC/LINE level of an audio input
If the peak indication appears (when set to the default MIC/LINE
level of “Middle (-20 dB)”)
If the input audio signal is too loud, the peak indication in the source viewer lights
red.
In this case, since the MIC/LINE level exceeds the standard input level, use the
following procedure to adjust it.
Example: When the peak indication has lit with MIC/LINE 2 connected to R and
MIC/LINE 1 connected to L, as illustrated below.
1
Press the MENU button.
2
In the top menu select [Audio MIC/LINE Level].
Input signal indication
LINE MIC/LINE
MIC/LINE
PUSH PUSH
AUDIO IN
8 76543
21
OFF
ON
MIC/LINE
2
MIC/LINE
1
RL