Filter
Top Products
5-10
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 5 Administrating the Access Point
Configuring Easy Setup
Configuring Easy Setup
You can now configure a network and radio in a single screen using the Easy Setup.
Network Configuration
To configure an access point using the network configuration, enter the values for the following fields:
• Hostname
• Server protocol (DHCP / Static)
• IP Address
• IP Subnet
• Default Gateway
• IPv6 Protocol (DHCP / Autoconfig / Static IP)
• IPV6 address
• Username
• Password
• SNMP Community
• Current SSID list (list SSIDs configured to the access point)
Radio Configuration
To configure an access point using Radio Configuration, configure the following fields:
• SSID—a 32 byte string.
• Broadcast SSID in beacon
• Security
• Role in Radio Network
–
Access point—Root device. This setting can be applied to any access point.
–
Repeater—Nonroot device. This setting also can be applied to any access point.
–
Root Bridge—This setting can be applied to any access point.
–
Non-Root Bridge—This setting can be applied to any access point.
–
Workgroup Bridge—This setting can be applied to any access point.
–
Universal Workgroup Bridge
–
Scanner—Access point functions as a network monitoring device. It continuously scans and
reports wireless traffic that it detects from other wireless devices on the wireless LAN in this
mode. All access points can be configured as a scanner.
Command Purpose
Step 1
enable level Log in to a specified privilege level.
For level, the range is 0 to 15.
Step 2
disable level Exit to a specified privilege level.
For level, the range is 0 to 15.