Filter
Top Products
12-12
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 12 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection
Configuring WDS
Configuring the Authentication Server to Support WDS
The WDS device and all access points participating in WDS must authenticate to your authentication
server. On your server, you must configure usernames and passwords for the access points and a
username and password for the WDS device.
If your server runs Cisco ACS, follow these steps to configure the access points on your server:
Step 1 Log into Cisco Identity Services Engine (ISE).
Step 2 Choose Administration > Network Resources > Network devices.
The Network Devices page appears.
Here you can add the WDS as a AAA client.
Figure 12-6 Cisco ISE Network Devices Page
Figure 12-7 Cisco ISE Network Devices Page Detailed
Step 3
Click Add to add the WDS as a new AAA client.
Step 4 In the Name field, enter the WDS device name. This name is significant only locally.
Optionally, enter a description for the WDS device.
Step 5 In the IP address field, enter the IP address of the WDS device.
Optionally, specify the device location and device type, but only if these categories have been configured
on the ISE.