Filter
Top Products
C-29
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Appendix C Error and Event Messages
SNMP Error Messages
Error Message SENSOR-3-VOLT_NORMAL: System sensor “d”(“d”) is now operating under
NORMAL voltage
Explanation
One of the measured environmental test points is under normal
operating voltage.
Recommended Action None.
Error Message SENSOR-3-VOLT_WARNING: Voltage monitor “d”(“d”) has exceeded voltage
thresholds
Explanation
One of the measured voltage test points indicates that voltage is out of normal range.
Explanation Check Power Supplies or contact TAC
SNMP Error Messages
Error Message SNMP-3-AUTHFAILIPV6: Authentication failure for SNMP request from
hostUnrecognized format ‘ %P’
Explanation
An SNMP request was sent by this host which was not properly authenticated.
Recommended Action Make sure that the community/user name used in the SNMP req has been
configured on the router.
Error Message SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue full
Explanation
Snmp packet dropped due to input queue full error
Recommended Action Use the command show snmp to see the number of packets dropped. Stop any
SNMP access to the device until the error condition is recovered.
Error Message SNMP-3-INTERRUPT_CALL_ERR: “s” function, cannot be called from
interrupt handler
Explanation
This message indicates that a call has been made to the function from an interrupt
handler. This is not permitted because it will fail and device will reboot down the stack in malloc
call.
Recommended Action If this messages recurs, copy it exactly as it appears and report it to your
technical support representative.