Cisco Systems OL-29225-01 Film Camera User Manual


 
18-5
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 18 Configuring SNMP
Configuring SNMP
Figure 18-1 SNMP Network
For information on supported MIBs and how to access them, see Appendix B, “Supported MIBs.”
Configuring SNMP
This section describes how to configure SNMP on your access point. It contains this configuration
information:
Default SNMP Configuration, page 18-5
Enabling the SNMP Agent, page 18-6
Configuring Community Strings, page 18-6
Specifying SNMP-Server Group Names, page 18-8
Configuring SNMP-Server Hosts, page 18-8
Configuring SNMP-Server Users, page 18-8
Configuring Trap Managers and Enabling Traps, page 18-8
Setting the Agent Contact and Location Information, page 18-10
Using the snmp-server view Command, page 18-11
SNMP Examples, page 18-11
Default SNMP Configuration
Table 18-3 shows the default SNMP configuration.
get-request, get-next-request,
get-bulk, set-request
Network device
get-response, traps
81949
SNMP manager
NMS
MIB
SNMP agent
Table 18-3 Default SNMP Configuration
Feature Default Setting
SNMP agent Disabled
SNMP community strings No strings are configured by default. However,
when you enable SNMP using the web-browser
interface, the access point automatically creates
the public community with read-only access to the
IEEE802dot11 MIB.
SNMP trap receiver None configured
SNMP traps None enabled