Filter
Top Products
8-10
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 8 Configuring Spanning Tree Protocol
Configuring STP Features
STP Configuration Examples
These configuration examples show how to enable STP on root and non-root access point/bridges with
and without VLANs:
• Root Bridge Without VLANs, page 8-10
• Non-Root Bridge Without VLANs, page 8-11
• Root Bridge with VLANs, page 8-12
• Non-Root Bridge with VLANs, page 8-14
Root Bridge Without VLANs
This example shows the configuration of a root bridge with no VLANs configured and with STP enabled:
hostname master-bridge-south
!
dot11 syslog
!
dot11 ssid visitor
!
dot11 ssid visitor2
!
dot11 guest
!
bridge irb
!
interface Dot11Radio0
no ip address
no ip route-cache
!
ssid visitor
!
antenna gain 0
stbc
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Dot11Radio1
no ip address
no ip route-cache
!
ssid visitor2
!
antenna gain 0
peakdetect
dfs band 3 block
stbc
channel dfs
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!