Filter
Top Products
13-22
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 13 Configuring RADIUS and TACACS+ Servers
Configuring and Enabling RADIUS
Note By default, the access point sends reauthentication requests to the authentication server with the
service-type attribute set to authenticate-only. However, some Microsoft IAS servers do not support the
authenticate-only service-type attribute. Depending on the user requirements, set the service-type
attribute to: dot11 aaa authentication attributes service-type login-user or dot11 aaa authentication
attributes service-type framed-user. By default the service type "login" is sent in the access request.
Table 13-6 Attributes Sent in Accounting-Request (stop) Packets
Attribute ID Description
1User-Name
4 NAS-IP-Address
5NAS-Port
6 Service-Type
25 Class
41 Acct-Delay-Time
42 Acct-Input-Octets
43 Acct-Output-Octets
44 Acct-Session-Id
46 Acct-Session-Time
47 Acct-Input-Packets
48 Acct-Output-Packets
49 Acct-Terminate-Cause
61 NAS-Port-Type
VSA (attribute 26) SSID
VSA (attribute 26) NAS-Location
VSA (attribute 26) Disc-Cause-Ext
VSA (attribute 26) VLAN-ID
VSA (attribute 26) Connect-Progress
VSA (attribute 26) Cisco-NAS-Port
VSA (attribute 26) Interface
VSA (attribute 26) Auth-Algo-Type