Filter
Top Products
8-12
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 8 Configuring Spanning Tree Protocol
Configuring STP Features
antenna gain 0
peakdetect
stbc
station-role non-root
bridge-group 1
!
interface GigabitEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
bridge-group 1
bridge-group 1 path-cost 40
!
interface BVI1
ip address dhcp client-id GigabitEthernet0
no ip route-cache
ipv6 address dhcp
ipv6 address autoconfig
ipv6 enable
!
bridge 1 priority 10000
bridge 1 protocol ieee
bridge 1 route ip
!
line con 0
line vty 0 4
login local
transport input all
!
End
Root Bridge with VLANs
This example shows the configuration of a root bridge with VLANs configured with STP enabled:
hostname master-bridge-hq
!
dot11 syslog
!
dot11 ssid vlan1
vlan 1
authentication open
!
dot11 guest
!
bridge irb
!
interface Dot11Radio0
no ip address
no ip route-cache
!
ssid vlan1
!
antenna gain 0
stbc
station-role root
!
interface Dot11Radio0.1
encapsulation dot1Q 1 native
no ip route-cache