Filter
Top Products
C-26
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Appendix C Error and Event Messages
Access Point/Bridge Messages
Access Point/Bridge Messages
Error Message APBR-4-SEND_PCKT_FAILED: Failed to Send Packet on port ifDescr
(error= errornum)errornum: status error number
HASH(0x2096974)
Explanation The access point or bridge failed to send a packet. This condition might be seen if there
is external noise or interference.
Recommended Action Check for sources of noise or interference.
Error Message APBR-6-DDP_CLNT_RESET: Detected probable reset of hosthost: host MAC
address HASH(0x2080f04)
Explanation
The access point or bridge detects that another infrastructre device has restarted.
Recommended Action If this message appears continuously, reboot the access point.
Cisco Discovery Protocol Messages
Error Message CDP_PD-2-POWER_LOW: %s - %s %s (%e)
Explanation
The system is not supplied with sufficient power.
Recommended Action Reconfigure or replace the source of inline power.
External Radius Server Error Messages
Error Message RADUYS:response-authenticator decrypt fail, paklen 32
Explanation
This error message means that there is a mismatch in the RADIUS shared key between
the RADIUS server and the access point.
Recommended Action Make sure that the shared key used on the RADIUS server and the access point
are the same.