Filter
Top Products
13-24
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 13 Configuring RADIUS and TACACS+ Servers
Configuring and Enabling TACACS+
TACACS+ Operation
When an administrator attempts a simple ASCII login by authenticating to an access point using
TACACS+, this process occurs:
1. When the connection is established, the access point contacts the TACACS+ daemon to obtain a
username prompt, which is then displayed to the administrator. The administrator enters a username,
and the access point then contacts the TACACS+ daemon to obtain a password prompt. The access
point displays the password prompt to the administrator, the administrator enters a password, and
the password is then sent to the TACACS+ daemon.
TACACS+ allows a conversation to be held between the daemon and the administrator until the
daemon receives enough information to authenticate the administrator. The daemon prompts for a
username and password combination, but can include other items, such as e.g. the user mother
maiden name, or any other information configured on the TACACS as being mandatory to identify
the user.
2. The access point eventually receives one of these responses from the TACACS+ daemon:
–
ACCEPT—The administrator is authenticated and service can begin. If the access point is
configured to require authorization, authorization begins at this time.
–
REJECT—The administrator is not authenticated. The administrator can be denied access or is
prompted to retry the login sequence, depending on the TACACS+ daemon.
–
ERROR—An error occurred at some time during authentication with the daemon or in the
network connection between the daemon and the access point. If an ERROR response is
received, the access point typically tries to use an alternative method for authenticating the
administrator.
–
CONTINUE—The administrator is prompted for additional authentication information.
After authentication, the administrator undergoes an additional authorization phase if authorization
has been enabled on the access point. Administrators must first successfully complete TACACS+
authentication before proceeding to TACACS+ authorization.
3. If TACACS+ authorization is required, the TACACS+ daemon is again contacted, and it returns an
ACCEPT or REJECT authorization response. If an ACCEPT response is returned, the response
contains data in the form of attributes that direct the EXEC or NETWORK session for that
administrator, determining the services that the administrator can access:
–
Telnet, rlogin, or privileged EXEC services
–
Connection parameters, including the host or client IP address, access list, and administrator
timeouts
Configuring TACACS+
This section describes how to configure your access point to support TACACS+. At a minimum, you
must identify the host or hosts maintaining the TACACS+ daemon and define the method lists for
TACACS+ authentication. You can optionally define method lists for TACACS+ authorization and
accounting. A method list defines the sequence and methods to be used to authenticate, to authorize, or
to keep accounts on an administrator. You can use method lists to designate one or more security
protocols to be used, thus ensuring a backup system if the initial method fails. The software uses the first
method listed to authenticate, to authorize, or to keep accounts on administrators; if that method does
not respond, the software selects the next method in the list. This process continues until there is
successful communication with a listed method or the method list is exhausted.