Filter
Top Products
15-10
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 15 Configuring QoS
Configuring QoS
Step 16 Use the Apply Policies to Interface/VLANs drop-down lists to apply policies to the access point Ethernet
and radio ports. If VLANs are configured on the access point, drop-down lists for each VLANs’ virtual
ports appear in this section. If VLANs are not configured on the access point, drop-down lists for each
interface appear.
Step 17 Click the Apply button at the bottom of the page to apply the policies to the access point ports.
The QoS Policies Advanced Page
The QoS Policies Advanced page (Figure 15-3)
Figure 15-3 QoS Policies - Advanced Page
Select Enable the QoS Element for Wireless Phones option and click Select Enable the QoS Element
for Wireless Phones option and click Apply to give top priority to all voice packets.
QoS Element for Wireless Phones
When you enable the QoS Element for Wireless Phones, the access point gives top priority to voice
packets even if you do not enable QoS. This setting operates independently from the QoS policies that
you configure.
Select dot11e to use the WMM / 802.11e version of QBSS Load IE. If you leave this selection blank,
the CCX pre-802.11e version of the QBSS Load IE is used. Use the pre-802.11e version if your wireless
clients are primarily 7920 phones with firmware 1.05 or older. Use the 802.11e version if your clients
are primarily WMM compatible clients.