Cisco Systems OL-29225-01 Film Camera User Manual


 
1-2
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 1 Overview of Access Point Features
New Features and Platforms in this Release
New Features and Platforms in this Release
For full information on the new features and updates to existing features in this release, see the Release
Notes for Autonomous Cisco Aironet Access Points and Bridges for Cisco IOS Release 15.3(3)JA.
For the full list of CLI commands supported in this release, see the Cisco IOS Command Reference for
Autonomous Cisco Aironet Access Points and Bridges, Cisco IOS Release 15.3(3)JA.
Note The proxy Mobile-IP feature is not supported in Cisco IOS Release 12.3(2)JA and later.
New Access Point Platforms Supported
This release supports the following new access point platforms:
Support for Cisco Aironet 3700 Series access point
This access point is built on 4x4:3(2.4GHz), 4x4:3(5GHz) MIMO technology, with integrated and
external antenna options, and supports 802.11a,b,g,n,ac.
Supported models are 3700E and 3700I
Supported operating modes are:
Root
Root Bridge
Non Root Bridge
Workgroup Bridge
Scanner
Spectrum
Repeater
Support for Cisco Aironet 2700 Series access point
This access point is built on 3x4:3(2.4GHz), 4x4:3(5GHz) MIMO technology, with integrated and
external antenna options, and supports 802.11a,b,g,n,ac. This access point has both primary and
secondary gigabit Ethernet ports. The primary port is gigabit Ethernet 0 and is the backhaul port.
The primary port can be set as trunk port. The secondary port is gigabitEthernet 1, and is the access
port. You can configure the secondary port to a VLAN ID using the interface configuration
command bridge multiple-port client-vlan vlan-id
Supported models are 2700E and 2700I
Supported operating modes are:
Root
Root Bridge