Filter
Top Products
20-28
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 20 Managing Firmware and Configurations
Working with Software Images
RCP requires a client to send a remote username on each RCP request to a server. When you copy an
image from the access point to a server by using RCP, the Cisco IOS software sends the first valid
username in this list:
• The username specified in the archive download-sw or archive upload-sw privileged EXEC
command if a username is specified.
• The username set by the ip rcmd remote-username username global configuration command if the
command is entered.
• The remote username associated with the current TTY (terminal) process. For example, if the user
is connected to the router through Telnet and was authenticated through the username command,
the access point software sends the Telnet username as the remote username.
• The access point host name.
For the RCP copy request to execute successfully, an account must be defined on the network server for
the remote username. If the server has a directory structure, the image file is written to or copied from
the directory associated with the remote username on the server. For example, if the image file resides
in the home directory of a user on the server, specify that user’s name as the remote username.
Before you begin downloading or uploading an image file by using RCP, do these tasks:
• Ensure that the workstation acting as the RCP server supports the remote shell (rsh).
• Ensure that the access point has a route to the RCP server. The access point and the server must be
in the same subnetwork if you do not have a router to route traffic between subnets. Check
connectivity to the RCP server by using the ping command.
• If you are accessing the access point through a Telnet session and you do not have a valid username,
make sure that the current RCP username is the one that you want to use for the RCP download. You
can enter the show users privileged EXEC command to view the valid username. If you do not want
to use this username, create a new RCP username by using the ip rcmd remote-username username
global configuration command to be used during all archive operations. The new username is stored
in NVRAM. If you are accessing the access point through a Telnet session and you have a valid
username, this username is used, and there is no need to set the RCP username. Include the username
in the archive download-sw or archive upload-sw privileged EXEC command if you want to
specify a username only for that operation.
• When you upload an image to the RCP to the server, it must be properly configured to accept the
RCP write request from the user on the access point. For UNIX systems, you must add an entry to
the .rhosts file for the remote user on the RCP server. For example, suppose the access point contains
these configuration lines:
hostname ap1
ip rcmd remote-username User0
If the access point IP address translates to ap1.company.com, the .rhosts file for User0 on the RCP
server should contain this line:
ap1.company.com ap1
For more information, refer to the documentation for your RCP server.