Cisco Systems OL-21636-01 Security Camera User Manual


 
6-25
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 6 Managing a FlexUNI/EVC ATM-Ethernet Interworking Service Request
Saving the FlexUNI/EVC Service Request
If the FlexUNI/EVC service request is successfully created, you will see the service request list window,
similar to what appears in
Figure 6-9.
Figure 6-9 FlexUNI/EVC Service Request Created
The newly created FlexUNI/EVC service request is added with the state of REQUESTED, as shown in
the figure.
Step 2 If, however, the FlexUNI service request creation failed for some reason (for example, a value chosen is
out of bounds), you are warned with an error message.
In such a case, you should correct the error and save the service request again.
Step 3 If you are ready to deploy the FlexUNI/EVC service request, see Deploying Service Requests,
page 11-1.