Filter
Top Products
5-7
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 5 Creating a FlexUNI/EVC ATM-Ethernet Interworking Policy
Setting the FlexUNI Attributes
Figure 5-3 EVC Policy Editor - ATM Interface Attributes Window
To set the ATM interface attributes, perform the following steps.
Step 7 Choose the Transport Mode from the drop-down list.
The choices are:
• VP—Virtual path mode. This is the default.
• VC—Virtual circuit mode.
Step 8 Choose the ATM Encapsulation from the drop-down list.
• AAL5SNAP
Step 9 Click Next.
The EVC Policy Editor - FlexUNI Attribute window appears, as shown in Figure 5-4.
Step 10 Continue with the steps contained in the next section, Setting the FlexUNI Attributes, page 5-7.
Setting the FlexUNI Attributes
This section describes how to set the FlexUNI attributes for the FlexUNI/EVC ATM-Ethernet
Interworking policy, as shown in
Figure 5-4.