Cisco Systems OL-21636-01 Security Camera User Manual


 
7-12
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 7 Creating an L2VPN Policy
Defining an Ethernet ERS (EVPL) Policy without a CE
Step 13 Choose an L2VPN Group Name from the drop-down list.
The choices are:
ISC
VPNSC
This attribute is used for provisioning the L2VPN group name on IOS XR devices.
Note The choices in the drop-down list are derived from a configurable DCPL property. For
information about how to define the L2VPN Group Name choices available in the drop-down
list, see Defining L2VPN Group Names for IOS XR Devices, page 2-14.
Step 14 Enter an E-Line Name to specify the point-to-point (p2p) E-line name.
This attribute is only applicable for IOS XR devices. If no value is specified for the p2p name, ISC
generates a default name consisting of the names of the two PEs forming the pseudowire, separated by
hyphens (for example, 6503-A----6503-B). If the default name is more than 32 characters, the device
names are truncated.
Step 15 Enter a VLAN NAME (optional) to specify a name to describe the VLAN.
The name must be one token (no spaces allowed.) The limit for the VLAN name is 32 characters. The
name has to be unique.
Step 16 Enter a Link Media type (optional) of None, auto-select, rj45, or sfp.
Usage notes:
The default is None.
When this attribute is used, a new CLI will be generated in the UNI interface to define the media
type.
The Link Media attribute is supported only for ME3400 platforms.
Step 17 Enter a Link Speed (optional) of None, 10, 100, 1000, Auto, or nonegotiate.
Step 18 Enter a Link Duplex (optional) of None, Full, Half, or Auto.
Step 19 Check the Use Existing ACL Name check box if you want assign your own named access list to the port.
By default, this check box is unchecked and ISC automatically assigns a MAC-based ACL on the
customer facing UNI port, based on values you enter in UNI MAC addresses (below).
Step 20 Enter a Port-Based ACL Name (if you checked the Use Existing ACL Name check box, as mentioned
in the previous step).
Note ISC does not create this ACL automatically. The ACL must already exist on the device, or be
added as part of a template, before the service request is deployed. Otherwise, deployment will
fail.
Step 21 Enter one or more Ethernet MAC addresses in UNI MAC addresses.
This selection is present only if you unchecked the Use Existing ACL Name check box. Click the Edit
button to bring up a pop-up window in which you enter MAC addresses to be allowed or denied on the
port. You can also specify a range of addresses by setting a base MAC address and a filtered MAC
address.
Step 22 Choose a UNI Port Type.