Cisco Systems OL-21636-01 Security Camera User Manual


 
4-3
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 4 Managing a FlexUNI/EVC Ethernet Service Request
Setting the Service Request Details
This window enables you to specify options for the service request, as well as configure directly
connected links and links with L2 access nodes. The options displayed in first section of the window
change, depending on the MPLS Core Connectivity Type that was specified in the policy (pseudowire,
VPLS, or local). For clarity, each of these scenarios is presented in a separate section below, to highlight
the different window configurations and behavior of the displayed options.
Proceed to the appropriate section, as determined by the MPLS Core Connectivity Type for the policy:
Pseudowire Core Connectivity, page 4-3
VPLS Core Connectivity, page 4-5
Local Core Connectivity, page 4-7
Instructions for setting up direct connect links and links with L2 access nodes are presented in later
sections.
Pseudowire Core Connectivity
If the MPLS Core Connectivity Type for the FlexUNI/EVC Ethernet policy is PSEUDOWIRE, the EVC
Service Request Editor window shown
Figure 4-1 appears.
Figure 4-1 EVC Service Request Details Window for Pseudowire Core Connectivity
Perform the following steps to set the attributes in the first section of the Service Request Details
window: