Cisco Systems OL-21636-01 Security Camera User Manual


 
8-14
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 8 Managing an L2VPN Service Request
Creating an L2VPN Service Request
Note ISC only displays the available interfaces for the service, based on the configuration of the underlying
interfaces, existing service requests that might be using the interface, and the customer associated with
the service request. You can click the Details button to display a pop-up window with information on
the available interfaces, such as interface name, customer name, VPN name and service request ID,
service request type, VLAN translation type, and VLAN ID information.
Step 9 If the PE role type is U-PE, click Select one circuit in the Circuit Selection column.
The NPC window appears. (See Figure 8-19.)
Figure 8-19 Select NPC
If only one NPC exists for the Chosen PE and PE interface, that NPC is auto populated in the Circuit
Selection column and you need not choose it explicitly.
Note If the PE role type is N-PE, the columns Circuit Selection and Circuit Details are disabled.
Step 10 Choose the name of the NPC from the Select column.
Step 11 Click OK.
Each time you choose a PE and its interface, the NPC that was precreated from this PE and interface is
automatically displayed under Circuit Selection. (See
Figure 8-20.) This means that you do not have to
further specify the PE to complete the link.
Figure 8-20 NPC Created
Step 12 If you want to review the details of this NPC, click Circuit Details in the Circuit Details column.
The NPC Details window appears and lists the circuit details for this NPC.