Cisco Systems OL-21636-01 Security Camera User Manual


 
8-26
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 8 Managing an L2VPN Service Request
Saving the L2VPN Service Request
Figure 8-37 Service Request Editor with Link Attributes Changed.
Step 16 When you are finished editing the end-to-end wires, click Save.
Saving the L2VPN Service Request
To save an L2VPN service request, perform the following steps.
Step 1 When you are finished with Link Attributes for all the Attachment Circuits, click Save to finish the
L2VPN service request creation. If the L2VPN service request is successfully created, you will see the
service request list window. (See
Figure 8-38.) The newly created L2VPN service request is added with
the state of REQUESTED, as shown in the figure.
Figure 8-38 L2VPN Service Request Created
Step 2 If, however, the L2VPN service request creation failed for some reason (for example, a value chosen is
out of bounds), you are warned with an error message. In such a case, you should correct the error and
save the service request again.
For information on deploying L2VPN service requests, see Deploying Service Requests, page 11-1.