Cisco Systems OL-21636-01 Security Camera User Manual


 
10-14
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 10 Managing a VPLS Service Request
Saving the VPLS Service Request
Saving the VPLS Service Request
To save a VPLS service request, perform the following steps.
Step 1 When you are finished with Link Attributes for all the Attachment Circuits, click Save to finish the
VPLS service request creation.
If the VPLS service request is successfully created, you will see the service request list window. (See
Figure 10-16.) The newly created VPLS service request is added with the state of REQUESTED, as
shown in the figure.
Figure 10-16 VPLS Service Request Created
Step 2 If, however, the VPLS service request creation failed for some reason (for example, a value chosen is
out of bounds), you are warned with an error message.
In such a case, you should correct the error and save the service request again.