Cisco Systems OL-21636-01 Security Camera User Manual


 
8-19
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 8 Managing an L2VPN Service Request
Creating an L2VPN Service Request
Step 10 If the PE role type is N-PE, the columns Circuit Selection and Circuit Details are disabled. In this case,
skip to Step 13.
Step 11 If the PE role type is U-PE, click Select one circuit in the Circuit Selection column.
The Select NPC window appears. (See Figure 8-27.)
Figure 8-27 Select NPC
Note If only one NPC exists for the Chosen PE and PE interface, that NPC is auto populated in the Circuit
Selection column and you need not choose it explicitly.
Step 12 If applicable, choose the name of the NPC from the Select column.
Step 13 Click OK.
The Attachment Tunnel Editor appears. (See Figure 8-28.)
Figure 8-28 NPC Created
Note Each time you choose a PE and its interface, the NPC that was precreated from this PE and interface is
automatically displayed under Circuit Selection. (See
Figure 8-28.) This means that you do not have to
further specify the PE to complete the link.
Step 14 Click OK.
The Service Request Editor window appears displaying the name of the selected PE in the AC1 column.
(See
Figure 8-29.)