Open as PDF
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
Chapter 8 Managing an L2VPN Service Request
Creating an L2VPN Service Request
Step 13 Click AC1 Link Attributes and edit the attributes if desired.
For more information, see the section Modifying the L2VPN Service Request, page 8-20.
Step 14 Click OK.
Step 15 Repeat Steps 6 through 14 for AC2.
Step 16 Click OK.
You see a window like Figure 8-14.
Figure 8-14 Attachment Circuits Selected
Step 17 Click Save.
The EWS (EPL) service request is created and saved in ISC.
Creating an ERS (EVPL), ATM, or Frame Relay L2VPN Service Request without a
This section includes detailed steps for creating an L2VPN service request without a CE present for ERS
(EVPL), ATM, and Frame Relay policies. If you are creating an L2VPN service request for an EWS
(EPL) policy, go to
Creating an EWS (EPL) L2VPN Service Request without a CE, page 8-16.
Perform the following steps.
Step 1 Create the L2VPN service request for ERS (EVPL) without a CE.
The L2VPN Service Request Editor window appears. (See Figure 8-15.)